Select up to 3 products
Used with optional accessory for exhausting Titan MPS oven cavity in laboratories that do not have exhaust systems. Exhaust Tube 1. 5 m (ID 76 mm, OD 82 mm) (one included with Titan MPS)
These HGA graphite walled tubes are pyrocoated to provide improved sensitivity and tube-to-tube reproducibility. The walled tube should be used in place of L'vov platform tubes when analyzing refractory elements such as Vanadium. NOTE: The tubes do not have an integrated platform and are not...
High Capacity Hydrocarbon Trap contains: 750 cc of preconditioned activated charcoal, Stainless steel body, ¼” brass compression fittngs with ferrules for installation, Maximum pressure 200 psi, Recommended ow rate up to 2 L per minute, Will remove hydrocarbon impurities (50 ppm or less) from inert...
These tubes are fit to perform on atomic absorption (AA) instruments for Shimadzu, are pyrocoated, have a 90° contact cone and are equivalent to Shimadzu part 206-50588. PerkinElmer supplies a wide range of graphite tubes for non-PerkinElmer instrumentation. Graphite tubes are made with the highest...
The new Advanced Platform design suspends the platform in the tube using three small pins in a triangular layout. This has the advantage of minimizing wall contact and reducing thermal conduction from the tube walls resulting in even and rapid heating almost exclusively from thermal radiation, an...
The partition graphite tube for Agilent is uncoated D6.9/3.9x24.9 mm and comes in a quantity of 10. It is fit to perform on atomic absorption (AA) instruments for Agilent and is equivalent to Agilent part 63-100015-00.
These HGA graphite tubes are pyrocoated to provide improved sensitivity and tube-to-tube reproducibility. They are slotted to accept L'vov platforms, PerkinElmer part number B3001256. PerkinElmer has over four decades of experience in the design/development of graphite furnace systems and materials....
Amalgamator Tube for SMS 100
Needle Port Tube for Rheodyne Injection Valves, Model 9725/8125/7125/7725
The Hitachi® Standard Graphite Tube uncoated, D7.8/4.7x30 mm and comes in a quantity of 10. The Standard Graphite Tube is fit to perform on a Hitachi® atomic absorption (AA) instrument. It is equivalent to Hitachi® part 180-7400.
Quartz Tube with Au/Pt Gauze for Amalgamation System
The pyrolytically coated GBC Standard Graphite Tube will perform on a GBC atomic absorption instrument.
Thermo Electron Omega Graphite Tubes are compatible with your Thermo Electron atomic absorption instrument.
The innovative separation probes and holders facilitate chromatography directly at the ionization source. This minimizes dead volume effects in the system for superior signal-to-noise ratios, enhanced sensitivity and narrower peaks. Compatible with LC/MS systems using Flexar SQ300 or AxION 2 TOF MS.