Lab Sampling Systems

Upon activation of the test, the chemical reacts with the sample collected on the swab to produce light. The amount of the light produced is proportional to the degree of potential contamination. Measurement of the light requires the use of a Clean-Trace® LM1 Luminometer and the results are...

These cost effective, Industrial Scoops from Sampling Systems are ideal for use in a variety of applications. Light duty construction Stainless Steel Fully welded construction

Red  PharmaScoops are brightly coloured scoops made possible by a special food grade dye. In line with HACCP guidelines the red range of scoops can be easily seen if they are left in the powder by mistake. Each PharmaScoop is individually bagged in a cleanroom, where it was manufactured from...

Burkle DispoTube ergonomic handle makes it easier to work and facilitates a good grip even under difficult conditions, for example with gloves. (21mm diameter) These single-use DispoSamplers are available in packs of 20 each. They are used to take target point samples, all-layer and cross-sectional...

Enable samples of liquid or powder to be taken and sent for testing in the same container, eliminating risk of cross contamination. Sterile Available in blue and clear The handle can be neatly snapped off once the sample has been taken. All Dippas come individually wrapped and are guaranteed sterile...

0.25mm i.d. Carbon fiber support SC-autosampler probe for ST nebulizers, 100 µL/min uptake rate, 150 cm capillary.

Manufactured from chemically-resistant polypropylene, this sampling device is perfect for corrosive environments and for hard to reach places A 500 mL bottle screws into the end of the 6 foot handle and is filled via four ports (two allowing liquid to enter and two allowing air to escape) Excellent...

This biocide-free cellulose sponge is pre-hydrated with Neutralizing Buffer diluent for convenient sample collection. The biocide-free cellulose sponge does not interfere with microorganism viability within 48 hours of refrigeration for Salmonella and E. coli and 72 hours for Listeria . The...

Burkle PowderDispo is ideal for taking a cross-sectional sample from within a bulk powder. Length of sample chamber 500mm. (22mm diameter) These single-use DispoSamplers are available in packs of 20 each. They are used to take target point samples, all-layer and cross-sectional samples of liquids,...

The SteriPlast® Bio sample scoop made of green PE is produced in our clean room of class 7 (10,000), individually wrapped in bio-PE film for disposable use and then sterilised by gamma rays. Green PE bio-plastic has all the suitable properties of conventional polyethylene but is manufactured...

The SteriWare® PharmaScoop® is the scoop of choice with thousands of pharmaceutical companie worldwide. The whole range is manufactured and packed in a cleanroom. The wide range of sizes means it meets all popular applications. Indivdiually bagged Full documentation available including batch...

Scoops. Flat Bottom. High-density Polyethylene. 25 mL liquid capacity. Heavy duty scoops with many industrial and laboratory applications. Suitable for liquids and powders.

pkg of 20 ea

The SteriPlast® Bio sample spoon made of green PE is produced in our clean room of class 7 (10,000), individually wrapped in bio-PE film for disposable use and then sterilised by gamma rays. Green PE bio-plastic has all the suitable properties of conventional polyethylene but is manufactured...

Microbial content and diversity within collected gut, rectal, vaginal, skin, oral, or soil samples can provide a wealth of clues about human and animal health. However, current microbiome collection methods subject the samples to harsh and stressful stabilization techniques such as freezing or harsh...

Unattended first flush grab sampling for organics or inorganics EPA compliant Ditch, grate or stream mounting HDPE or glass bottles EPDM gasket Storm Water Sampler collects a full one liter first flush grab sample into a 1000 mL Nalgene® HDPE sample bottle within the first minutes of storm water...

The SteriWare™ Disposable Bowl is ideal for laboratories, production & small scale work. Key Features: Moulded & packed in a Class 100,000 Cleanroom Individually bagged Made from FDA, EC 1935/2004 & EU 10/2011 conforming HDPE BSE/TSE free Full batch traceability Available...

SingleSample® Disposable Polyethylene Bailers Eliminates field clean-up and cross-contamination Rugged, high-density polyethylene Each unit individually decontaminated with Liquinox™ washing and DI water rinse Ready-to-use Capacity approximately 1 L Friction-fit nozzle for easy, no-splash...

Benefits of our stainless steel buckets with lid: Bucket with pouring spout Made from 316L Stainless Steel Crevice free interior Not graduated Swing handle Supplied with skirt band Drop on lid that covers spout completely (lid sold seperately)

The ChemoSampler was developed for sampling aggressive liquids, e.g. acids, alkalis, detergents. The samples are drawn directly into the screw-on original sampling bottle. The tamperproof bottle closure of these bottles with original safety ring ensures unadulterated sample transport. Samples can be...

Sampler for ground water samples from wells, pits and other sources. Fits all normal well shafts with control openings to Ø 2", without tilting or getting stuck. Ultra pure materials guarantee the highest degree of sample purity. Easy to clean thanks to rounded edges and threads....